Start a Membean Normal Session

How it works

1. Connect Membean

   Save the student username and password.

2. Choose duration

   Select the requested training length.

3. Tune pacing

   Set accuracy, question delay, and learning-page delay.

4. Start or schedule

   Run now or save the chosen schedule.

1. Connect the Membean account

1. Open Membean

   Choose Membean in the dashboard, then select Normal Session.

2. Select Connect account

   Enter the Membean username and password used by the student.

3. Save the login

   Wait for the account strip to show that the login is ready.

2. Configure the session

Choose a duration from 5 to 60 minutes. The accuracy target is a range, so each question can vary within that band. Question delay controls the wait before answers, while learning-page delay controls how long learning screens remain open.

• Accuracy target defaults to 80–90%.
• Question delay defaults to 2–5 seconds.
• Learning-page delay defaults to 0–5 seconds.

3. Add optional Discord notifications

Paste a Discord webhook, enable Discord notifications, and save the webhook. The notification setting is optional and does not change the training behavior.

4. Start or schedule the session

Select Run now to start immediately. The run card shows session logs and provides Cancel session while work is active. To automate later, choose the schedule type and time, select weekdays when needed, and save the schedule.

Quick answers

Can I stop an active Normal Session?

Yes. Use Cancel session in the run card while the job is queued or running.

Can I change a saved schedule?

Yes. Update the controls and save again, or delete the schedule and create a new one.